</a>led" title="led">led" title="led">led design flexibility and seamless integration to today’s demanding connectivity solutions.

LPC11U24 主要特性和优势:

ARM Cortex-M0 processor, running at frequencies of up to 50 MHz

ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC)

Non-Maskable Interrupt (NMI) input selectable from several input sources

System tick timer

Up to 32 kB on-chip flash program memory

Up to 4 kB on-chip EEPROM data memory

Up to 10 kB SRAM data memory

16 kB boot ROM

In-System Programming (ISP) and In-Application Programming (IAP)

ROM-based USB drivers. Flash updates via USB supported

ROM-based 32-bit integer division routines

Standard JTAG (Joint Test Action Group) test interface

Serial Wire Debug

Up to 54 General-Purpose I/O (GPIO) pins

Up to 8 GPIO pins can be selected as edge and level sensitive interrupt sources

Two GPIO grouped interrupt modules

High-current source output driver (20 mA) on one pin

High-current sink driver (20 mA) on true open-drain pins

Four general-purpose counter/timers

Programmable Windowed WatchDog Timer (WWDT)

10-bit ADC with input multiplexing among eight pins

USB 2.0 full-speed device controller

USART (Universal Synchronous Asynchronous Receiver/Transmitter)

Two SSP (Synchronous Serial Port) controllers

I2C-bus interface supporting the full I2C-bus specification and Fast-mode Plus

Crystal Oscillator with an operating range of 1 MHz to 25 MHz

12 MHz high-frequency Internal RC oscillator (IRC)

Internal low-power, low-frequency WatchDog Oscillator (WDO)

PLL allows CPU operation up to the maximum CPU rate

A second, dedicated PLL is provided for USB

Clock output function with divider

Integrated PMU (Power Management Unit)

Power profiles residing in boot ROM

Four reduced power modes

Processor wake-up

Power-On Reset (POR)

Brownout detect with four separate thresholds for interrupt and forced reset

Unique device serial number for identification

Single 3.3 V power supply (1.8 V to 3.6 V)

Temperature range -40 ℃ to +85 ℃

LPC11U24 应用:

Consumer peripherals

Medical

Industrial control

Industrial control

USB audio devices

图1.LPC11U24 框图


图2.自供电设备的USB接口连接图

Rapid Prototyping for USB devices, battery applications and low-cost 32-bit ARM® Cortex™-M0 based designs

图3.mbed NXP LPC11U24 MCU模块外形图

The mbed NXP LPC11U24 Microcontroller in particular is designed for prototyping low cost USB devices, battery powered applications and 32-bit ARM® Cortex™-M0 based designs. It is packaged as a small DIP form-factor for prototyping with through-hole PCBs, stripboard and breadboard, and includes a built-in USB FLASH programmer.

图4.mbed NXP LPC11U24 MCU模块连接图

图5.mbed NXP LPC11U24 MCU模块电路图(1)

图6.mbed NXP LPC11U24 MCU模块电路图(2)

图7.mbed NXP LPC11U24 MCU模块电路图(3)

图8.mbed NXP LPC11U24 MCU模块电路图(4)
详情请见:
http://www.nxp.com/documents/data_sheet/LPC11U2X.pdf
和
http://mbed.org/media/uploads/chris/mbed-010.2-schematic.pdf
以及
http://www.nxp.com/documents/user_manual/UM10462.pdf